A full installation procedure is shown
below:
Supplied
in 2m wide x 30m long rolls, it can provide excellent
turf reinforcement if used and fixed as directed.
Installation on Existing Grassed areas
1. Fill any depressions with a 70:30 mixture of
sharp sand and topsoil, level and firm. Cut grass
short.
2. Unroll the Turf reinforcement mesh and fix one end using our metal
U-Pins. Pull taut, and pin approx. every 1m either
side of the mesh ensuring mesh lies flat to surface.
3. Lay adjacent turf reinforcement net rolls next to the fixed mesh rolls and
overlap at least 150mm and repeat the fixing process.
4. Secure overlaps and all external edges every
1 metre.
5. When you are satisfied that the mesh is laid
flat and securely, brush a dressing of good quality
sandy topsoil over the mesh. Ensure that the mesh
filaments are covered and the apertures are filled.
This will help promote root growth around the mesh.
6. Any areas that have been levelled with sandy
topsoil should be seeded.
7. Pedestrians and traffic should be kept off
the treated areas until the grass has become fully
established over the mesh. This usually takes at
least one growing season.
8. Initial mowing can be done, but set mowers
to cut fairly high, so that contact with the mesh
is not made. When the grass is established and
the roots are entwined with the mesh, the grass
can be cut normally.
Newly Sown Areas
1. Ensure that the surface is level, filling any
uneven areas with a mixture of sharp sand and topsoil.
Remove any debris / stones or rocks.
2. Thoroughly prepare the surface and firm.
3. Continue with Points 2-8 as above
